Last Updated on
So there are some tips for bike owners to keep in mind if they wish to improve fuel efficiency of their bike:
- First comes the lubricant a.k.a Engine oil. Always use the correct grade of the engine oil specified by the manufacturer. No matter by company of oil but the grade of the oil should be correct. For eg: If a bike is recommended for 20W40 grade. Then you should only use the grade 20W40. Although you can choose between different companies. Also keep checking oil level if it is low than up mark top it up or change the oil accordingly. Proper lubrication will decrease friction.
- Air Filter should be clean and not torn. A dirty air filter will be clogged and not allow enough and fresh air to air intake.
- Spark plug must be cleaned if there is any kind of deposit on it.
- Clutch components should be in fine shape. Proper clutch play, clutch plates should not be worn out.
- The carburetor should be clean and it should be tuned with correct air/fuel ratio for optimum performance. Running too lean( less fuel more air) will result in rough engine and running too rich( more fuel less air) will overheat the engine. A properly tuned carburettor can result in better mileage.
- Tyres should be properly inflated as per recommended. Underinflated tyres will cause engine to draw more power to push the wheels. Also overinflated tyres will reduce the proper control over the vehicle.
- Chain must pe properly adjusted, clean and lubricated. It should not be too lose or too tight.
More tips to improve fuel efficiency
- If possible try to fill petrol at night or in early morning as the weather is cool. This is so because fuel is highly volatile and easily evaporates / loses density under heat. Remember every drop counts.
- Even at idling, the engine consumes a decent amount of fuel so make sure that the idling rpm of the engine isn’t very high. Turn off the engine at red signal more than 10 seconds.
- Gently increase the rpm of engine and shift gears between 3000-4000 rpm. Don’t unnecessarily rev the engine. Don’t ride on clutch. Clutch should only be used while changing of gears.
- (If possible) ride at speeds between 40-50 kmph on top gear(bikes equipped with 4 gears). Ride between 45-55 kmph on top gear( bikes equipped with 5 gears).
- Plan your journey well before trip take shorter route with good roads.
- Avoid brake-riding at all costs. Many riders casually keep the brake pedal pressed while riding. This increases the load on the engine and also wears out the brake pads. Also avoid harsh braking.
- When the engine is not running for more than 8 to 10 hours then it is referred to cold engine. When starting the bike let the engine idle for at-least a minute to cause the engine oil to come at operating temperature.
- If possible, ride at a constant speed. Riding on constant speed is the key to achieve good mileage.